MCP2542FDT-E/SN

- Supports CAN 2.0 and CAN with Flexible Data Rate (CAN FD) Physical Layer Transceiver Requirements

- Optimized for CAN FD at 2, 5 and 8 Mbps Operation - Maximum propagation delay: 120 ns - Loop delay symmetry: - 10%/+10% (2 Mbps)

- Wake-up on CAN activity, 3.6 μs filter time

- Wake-up on Pattern (WUP), as specified in ISO11898-2:2015, 3.6 μs activity filter time

- Implements ISO11898-2:2003, ISO11898-5:2007, and ISO/DIS11898-2:2015

- Qualification: AEC-Q100 Rev. G, Grade 0 ( -40°C to +150°C)

- Very Low Standby Current (4 μA, typical)

- VIO Supply Pin to Interface Directly to CAN Controllers and Microcontrollers with 1.8V to 5V I/O

- CAN Bus Pins are Disconnected when Device is Unpowered - An unpowered node or brown-out event will not load the CAN bus - Device is unpowered if VDD or VIO drop below its POR level

- Detection of Ground Fault: - Permanent Dominant detection on TXD - Permanent Dominant detection on bus

- Automatic Thermal Shutdown Protection

- Suitable for 12V and 24V Systems

- Meets or Exceeds Stringent Automotive Design Requirements Including “Hardware Requirements for LIN, CAN and FlexRay Interfaces in Automotive Applications”, Version 1.3, May 2012 - Conducted emissions @ 2 Mbps with Common-Mode Choke (CMC) - Direct Power Injection (DPI) @ 2 Mbps with CMC

- Meets SAE J2962/2 “Communication Transceiver Qualification Requirements - CAN” - Radiated emissions @ 2 Mbps without a CMC

- High Electrostatic Discharge (ESD) Protection on CANH and CANL, meeting IEC61000-4-2 up to ±13 kV

- Temperature ranges: - Extended (E): -40°C to +125°C - High (H): -40°C to +150°C

- The MCP2542FD/4FD and MCP2542WFD/4WFD CAN transceiver family is designed for high-speed CAN FD applications up to 8 Mbps communication speed. The maximum propagation delay was improved to support longer bus length.

- The device meets the automotive requirements for CAN FD bit rates exceeding 2 Mbps, low quiescent current, electromagnetic compatibility (EMC) and electrostatic discharge (ESD).