PIC24FJ128GA306-I/PT
Microcontrollers
Manufacturer
MPN
PIC24FJ128GA306-I/PT
Product Type
Core Processor
PIC
Maximum Clock Speed
32 MHz
Package / Case
TQFP-64
Datasheet
Key Attributes
General Purpose, 16-Bit Flash Microcontrollers with LCD Controller and XLP Technology
Technical Specifications
| Type | Description |
|---|---|
| Core Processor | PIC |
| Core Bits | 16 |
| Maximum Clock Speed | 32 MHz |
| Flash Memory | 128 KB |
| Number of I/O | 53 |
| Flash Type | FLASH |
| Type | Description |
|---|---|
| Adc Bits | 10.0 |
| Oscillator Type | Built-in |
| Eeprom Bytes | - |
| Operating Temp | -40°C ~ +85°C |
| Working Voltage V | 2.8 V |
| Package / Case | TQFP-64 |
Product Introduction
PIC 16 Bit 32MHz TQFP-64(10x10) Microcontrollers RoHS
Features
- Multiple Power Management Options for Extreme Power Reduction:
- VBAT allows the device to transition to a backup battery for the lowest power consumption with RTCC
- Deep Sleep allows near total power-down with the ability to wake-up on external triggers
- Sleep and Idle modes selectively shut down peripherals and/or core for substantial power reduction and fast wake-up
- Doze mode allows CPU to run at a lower clock speed than peripherals
- Alternate Clock modes Allow On-the-Fly Switching to a Lower Clock Speed for Selective Power Reduction
- Extreme Low-Power Current Consumption for Deep Sleep:
- WDT: 270 nA @3.3V typical
- RTCC: 400 nA @ ≈32 kHz, 3.3V typical
- Deep Sleep current, 40 nA, 3.3V typical
- LCD Display Controller:
- Up to 60 segments by 8 commons
- Internal charge pump and low-power, internal resistor biasing
- Operation in Sleep mode
- Up to Five External Interrupt Sources
- Peripheral Pin Select (PPS): Allows Independent I/O Mapping of Many Peripherals
- Five 16-Bit Timers/Counters with Prescaler:
- Can be paired as 32-bit timers/counters
- Six-Channel DMA supports All Peripheral modules:
- Minimizes CPU overhead and increases data throughput
- Seven Input Capture modules, each with a Dedicated 16-Bit Timer
- Seven Output Compare/PWM modules, each with a Dedicated 16-Bit Timer
- Enhanced Parallel Master/Slave Port (EPMP/EPSP)
- Hardware Real-Time Clock/Calendar (RTCC):
- Runs in Deep Sleep and VBAT modes
- Two 3-Wire/4-Wire SPI modules (support 4 Frame modes) with 8-Level FIFO Buffer
- Two I²C modules Support Multi-Master/Slave mode and 7-Bit/10-Bit Addressing
- Four UART modules:
- Support RS-485, RS-232 and LIN/J2602
- On-chip hardware encoder/decoder for IrDA
- Auto-wake-up on Auto-Baud Detect
- 4-level deep FIFO buffer
- Programmable 32-Bit Cyclic Redundancy Check (CRC) Generator
- Digital Signal Modulator Provides On-Chip FSK and PSK Modulation for a Digital Signal Stream
- Configurable Open-Drain Outputs on Digital I/O Pins
- High-Current Sink/Source (18 mA/18 mA) on All I/O Pins
- 10/12-Bit, 24-Channel Analog-to-Digital (A/D) Converter:
- Conversion rate of 500 ksps (10-bit), 200 ksps (12-bit)
- Conversion available during Sleep and Idle
- Three Rail-to-Rail Enhanced Analog Comparators with Programmable Input/Output Configuration
- On-Chip Programmable Voltage Reference
- Charge Time Measurement Unit (CTMU):
- Used for capacitive touch sensing, up to 24 channels
- Time measurement down to 1 ns resolution
- CTMU temperature sensing
- Modified Harvard Architecture
- Up to 16 MIPS Operation @32 MHz
- 8 MHz Internal Oscillator:
- 4x PLL option
- Multiple clock divide options
- Fast start-up
- 17-Bit x 17-Bit Single-Cycle Hardware Fractional/Integer Multiplier
- 32-Bit by 16-Bit Hardware Divider
- 16x16-Bit Working Register Array
- C Compiler Optimized Instruction Set Architecture
- Two Address Generation Units for Separate Read and Write Addressing of Data Memory
- Operating Voltage Range of 2.0V to 3.6V
- Two On-Chip Voltage Regulators (1.8V and 1.2V) for Regular and Extreme Low-Power Operation
- 20,000 Erase/Write Cycle Endurance Flash Program Memory, Typical
- Flash Data Retention: 20 Years Minimum
- Self-Programmable under Software Control
- Programmable Reference Clock Output
- In-Circuit Serial Programming (ICSP) and In-Circuit Emulation (ICE) via 2 Pins
- JTAG Boundary Scan Support
- Fail-Safe Clock Monitor Operation:
- Detects clock failure and switches to on-chip, low-power RC oscillator
- Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
- Brown-out Reset (BOR) with Operation Below VBOR
- High/Low-Voltage Detect (HLVD)
- Flexible Watchdog Timer (WDT) with its Own RC Oscillator for Reliable Operation
- Standard and Ultra Low-Power Watchdog Timers (ULPW) for Reliable Operation in Standard and Deep Sleep modes
Datasheet
Alternative Parts
Common PIC24FJ128GA306-I/PT alternatives overseas buyers search for:
- PIC24FJ128GA306T-I/PT (request quote)
- PIC24FJ128GC006-I/PT (request quote)
- PIC24FJ256GA406T-I/PT (request quote)
- PIC24FJ128GA106-I/PT (request quote)
- PIC24FJ128GA106T-I/PT (request quote)
- PIC24FJ128GA406T-I/PT (request quote)
- PIC24FJ128GA406-I/PT (request quote)
- PIC24FJ256GA406-I/PT (request quote)
- PIC24FJ128GA606-I/PT (request quote)
- PIC24FJ128GA606T-I/PT (request quote)
- PIC24FJ128GB606T-I/PT (request quote)
- PIC24FJ128GB606-I/PT (request quote)
Compliance & Export Codes
| Type | Details |
|---|---|
| RoHS | ROHS3 |
| ECCN | 3A991A2 |
| Type | Details |
|---|---|
| CNHTS | 8542319090 |
Sourcing Information
Looking for a reliable source for PIC24FJ128GA306-I/PT from Microchip Technology? SZ Procure is a China electronics sourcing partner, helping international buyers source components through our supplier network in Shenzhen.
For PIC24FJ128GA306-I/PT, we can check current supplier availability, compare quotations from multiple sources, coordinate purchasing, and arrange pre-shipment inspection and shipment consolidation according to your requirements.
Ready to source PIC24FJ128GA306-I/PT? Send your requirement through Request a Quote and we'll help check sourcing options and procurement costs.